Configuracion de Router

Relayd Wireless Bridge in OpenWRT

Sets up a wireless bridge in OpenWRT using relayd.

Steps:

Collect Info

    Router WIFI SSID & password

    Router IP address, subnet mask: Example 192.168.100.1 / 255.255.255.0

    Choose an IP address in the router's subnet for the bridge: Example 192.168.100.4

    Choose an IP address in a different subnet for the bridge lan (used to configure the bridge itself): Example 192.168.8.1

Set Bridge LAN IP Address

    Menu -> Network -> Interfaces

    LAN -> Click Edit

    IPv4 address: Example 192.168.8.1

    DHCP Server -> General Setup -> Ignore Interface [X]

    Click Save & Apply

    Configure client PC to manually use 192.168.8.x address on ethernet and reconnect

Connect Bridge to Router WLAN

    Menu -> Network -> Wireless

    Click Scan

    Click Join Network

    WPA passphrase: your wifi password

    Click Submit

    Click Save & Apply

Test Connection to Internet

    Menu -> Network -> Diagnostics

    Click Ping

Install Relayd

    Menu -> System -> Software

    Click Update lists

    Filter: relay, Click Find Package

    Look for luci-proto-relay and relayd

    Check in installed packages - see if they're already installed.

    Check in available packages - click Install

Add Bridge Interface

    Menu -> Network -> Interfaces

    Click Add new interface...

    Name of the new interface: stabridge

    Protocol of the new interface: Relay bridge

    Click Submit

    Relay between networks: lan: and wwan:

    Local IPv4 Address: Example 192.168.100.1

    Click 'Save and Apply'

Update LAN Interface

    Menu -> Network -> Interfaces

    LAN -> Click Edit

    IPv4 Gateway: Example 192.168.100.1

    Custom DNS: Example 192.168.100.1

    DHCP: Ignore Interface [X]

Add Firewall Zone

    Menu -> Network -> Firewall

    Zones: Click Add

    Name: bridgezone

    Forward: accept

    Covered networks: lan: and wwan:

    Click 'Save and Apply'

Reboot bridge, change PC ethernet port back to automatic (DHCP)